NZXT AER RGB 2-140mm - HF-2814C-DB - Advanced Lighting Customizations - Winglet Tips - Fluid Dynamic Bearing - LED RGB PWM Fan - Twin Fans (Lighting. removed Reply FrugalWtfPriceBot Additional comment actions. The first fan connector with 4-pins on the fan splitter will be the primary fan. I’m using 3 Pack AER 2 120 Fans that I’ve used for my S340 Elite then I add 140 AER 2 Fan as a top exhaust. To connect more than three fans, use the included fan splitters. Integrating seamlessly into the HUE 2 ecosystem, Aer RGB 2 fans deliver optimal airflow and advanced lighting customization. Connect up to three fans directly to the three channels using the connections from the fans.RGB Connector - Aer P 120mm Radiator Fans (2 Included) Visit the NZXT Store 18,149 ratings. Step 4) Connecting your case fans to the Controller Do I need NZXT CAM software to control the Kraken 120 RGB. The upper connector is from the Kraken 120 connected via the. You can also use any provided extension cables from the NZXT RGB accessories if it does not reach Improved Pump - Powered by CAM V4 - RGB Connector - AER RGB 2 120mm Radiator Fans (3 Included.Using the lighting connection cable provided with your NZXT RGB accessory, connect to one of the two LED channels located on the side of the controller.Step 3) Connecting your NZXT RGB Accessories to the Controller For eyecandy, Corsair ML series fans have 4 LEDs inside the fan hub that doesnt change its brightness depending on the fan RPM. Once done, connect your Controller to your SATA power As far as warranty goes, NZXT gives its AER RGB fans 2 years of warranty while Corsair gives their ML series fans 5 years of warranty.First, ensure your PC is completely turned off and free of power.Step 2) Installing the Controller inside your build Ensure you have a free SATA power connection from your PSU and USB 2.0 header on your motherboard before attempting installation.You can choose to either install the controller first in your build using the provided velcro and magnetic strips or install your fans/RGB accessories to the controller first - NZXT H5 Flow - NZXT Kraken X63 - Gigabyte Z790 Aorus DDR4 - Intel i5 13600K - Zotac Trinity RTX 4070ti - Corsair rm850x - One extra fan 120mm (more than one extra will not fit) 151.Step 1) Preparing the RGB & Fan Controller for Installation
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |